The short answer
For most Moraga homes, a good AC installation starts with a room-by-room load calculation and a choice between central air and a heat pump. If your gas furnace is aging, a heat pump can handle both cooling and heating. That matters because Bay Area Air District rules will require gas furnaces manufactured from 2029 to meet a zero-NOx standard.
Adding or replacing air conditioning in a Moraga home involves more than picking a unit. The right system depends on your home's size, insulation, ductwork, and electrical panel, and on how you plan to heat the house in the years ahead. ExpertFlow HVAC Repair Service installs central air conditioners, heat pumps, and ductless systems for homeowners in Moraga's 94556 and 94575 ZIP codes. We're based in Pleasanton, about 18 miles southeast of Moraga, and we work throughout Contra Costa County. Here's how we approach an AC installation and what to consider before you decide.
Sizing an AC System for Your Moraga Home
An air conditioner that's too large cools the house quickly but shuts off before it removes much humidity, and it cycles on and off more often than it should. One that's too small runs constantly on hot afternoons and still can't keep up. Neither is comfortable, and both wear out equipment sooner.
We size systems with a room-by-room load calculation, not a rule of thumb based on square footage. The calculation accounts for details that vary a lot from house to house: which way the windows face, how much afternoon sun hits each side of the house, attic insulation, ceiling height, and whether rooms sit over a garage or crawlspace. On a hillside lot, one side of a house can get far more sun than the other, so we look at the whole home, not just the area around the thermostat.
Central AC or Heat Pump?
If you have a gas furnace and want cooling, you can add a standard central air conditioner that shares the furnace's blower and ductwork. You can also install a heat pump, which uses the same outdoor unit to cool in summer and heat in winter.
The choice often depends on the age of your furnace. Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. The rule doesn't require you to remove working equipment. It applies only when an existing furnace fails or is replaced.
If your furnace is fairly new, a central AC may be the simpler choice. If it's older and likely to need replacement in the next few years, installing a heat pump now covers both cooling and heating and saves you a second project later. We'll walk you through both options and what each involves for your house.
Homes Without Ductwork
Some Moraga homes were built with wall heaters, floor furnaces, or radiant heat and have no ducts at all. Others have ducts that are undersized, leaky, or routed through tight crawlspaces. Adding cooling to these homes usually follows one of these paths:
We'll also check your electrical panel. A home that has never had air conditioning sometimes needs a new circuit or a panel upgrade to support an AC or heat pump, and it's better to know that before the installation date.
- Ductless mini-split heat pumps: an outdoor unit connected to wall-mounted or ceiling heads in individual rooms
- New ductwork run through the attic or crawlspace, where there's enough room to do it well
- Repairing, sealing, or resizing existing ducts so a new central system can deliver air where it's needed
What to Expect on Installation Day
Once you've chosen a system, the work typically goes like this:
Air conditioner and heat pump installations generally require a building permit and an inspection. We'll explain how that fits into your schedule when we plan the job.
- We confirm the equipment, the outdoor unit location, and the thermostat placement with you before work begins
- We remove any old equipment and properly recover its refrigerant
- We set the outdoor unit on a level pad, with attention to clearances, noise toward bedrooms and neighbors, and access for future service
- We install and test the refrigerant lines, condensate drainage, and electrical connections
- We start the system, check airflow and refrigerant charge, and show you how to use the thermostat and change the filter
Rebates and Tax Credits in 2026
The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations after that date, so it won't apply to a system installed now.
Local programs may still help. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before including it in any quote.
More services in Moraga
- AC Repair in Moraga
- Heating Repair in Moraga
- Heat Pump Installation in Moraga
- Furnace Repair in Moraga

